Flash plugin [Slimjet 19.0.2.0]

[pietpeuk]

I already wanted to attach the bad Preferences file, but that seems not possible in the forum.
Anyway, I emailed it.
Some more info that might be helpful:
1> When you have a bad Preferences file and you sync everything by logging in and sync, the error gets synced too, because deleting the Preferences file and then syncing again, brings back the error.
2> because of the above, I forgot the whole syncing, deleted the Preferences and went into settings and set everything by hand.
Seemed to work fine, but in a few minutes, to my surprise, the error was back again.
I deleted the Preferences file again, set everything by hand again (by memory, so there might be a slight difference) and now everything works fine.
I have no idea what happened here.
The obvious is to think that one specific setting screws things up, but I have a hard time believing that.
But if it is one specific setting and somebody finds it, I hope they will report it here.

[pietpeuk]

This message was created automatically by mail delivery software.

A message that you sent could not be delivered to one or more of
its recipients. This is a permanent error. The following address(es)
failed:

support@flashpeak.com:
no valid MX hosts found

[oftentired]

Attach it and send it to Flashpeak via the Online feedback webpage.

Online feedback

[flashpeak]

That is not supposed to happen. I've a lot of emails through that mailbox every day. But as indicated by oftentired, you can send it through the online feedback page. I haven't received anything from you so far.

We disabled the forum attachment at one point since there were some malicious attack on our website and we decided to tighten all the potential loopholes on the website.

This message was created automatically by mail delivery software.

A message that you sent could not be delivered to one or more of
its recipients. This is a permanent error. The following address(es)
failed:

support@flashpeak.com:
no valid MX hosts found

[Anonymosity]

When I visit that page and try to run that animation, the whole page reloads. I have Flash set to ask, but it does not ask. It simply will not run. I have Slimjet 21.0.8.0 on MacOS 10.12.6.

[sleeper10]

If you click the lock icon near the url address, you should be able to select allow flash, then reload. That worked for me anyway.

[Anonymosity]

Attach it and send it to Flashpeak via the Online feedback webpage.

Online feedback

Should the title of that feedback page not be "Slimjet Online Feedback" rather than "SlimBrowser Online Feedback"? That title is outdated.

[oftentired]

Attach it and send it to Flashpeak via the Online feedback webpage.

Online feedback

Should the title of that feedback page not be "Slimjet Online Feedback" rather than "SlimBrowser Online Feedback"? That title is outdated.

When I go to the feedback link it says Slimjet for me. Which browser are you running when you click the link?

[Anonymosity]

I was using Slimjet 22.0.4.0. I mean the title of the page, not the address. I just checked the link. The page still has the same title.

[oftentired]

I was using Slimjet 22.0.4.0. I mean the title of the page, not the address. I just checked the link. The page still has the same title.

I think that has to do with which server is hosting the webpage. I think he repurposed the Slimbrowser server for some aspects of Slimjet after moving to Slimjet from Slimbrowser. However, the internet is still being told the Slimbrowser info from the server.